FT-IAQ6000 MOLD COAT WHITE

IAQ 6000 Mold Resistant Coating

Description

IAQ 6000 is a white, tintable, mold-resistant coating* formulated with a fungistatic agent that inhibits mold growth on the dry coating surface. This durable, flexible, and permeable 100% acrylic water-based coating is ideal for use on wood, plaster, wallboard, sheetrock, concrete, masonry block, primed metal, and galvanized metal.

*Note: Resistance applies to mold growth on the dry coating surface only.

Features

• Independently tested for mold resistance per ASTM G21 and ASTM D-3273 standards

• Contains fungistatic agents to resist mold growth*

• Tintable formula, customizable with universal colorants

• 100% acrylic, water-based, environmentally friendly coating

Surface Preparation

• Ensure all surfaces are clean and free of dust, mildew, mold, dirt, grease, loose paint, oil, glue size, calcimine, wax, soap, or other contaminants.

• Clean mold-stained areas with Advanced Peroxide Cleaner or EPA-registered antimicrobial disinfectants such as IAQ 2000, IAQ 2500, ShockWave, or ShockWave RTU.

• Patch surface irregularities with vinyl patching paste or an appropriate compound.

• IAQ 6000 is self-priming over bare sheetrock, composition board, ceiling tile, and concrete.

Substrate Specific Guidelines

• Wallboard, Sheetrock, Gypsum Board: Sand joint cement smooth; avoid abrading paper.

• Ferrous Metal: Clean thoroughly and prime with IAQ 4000 rust-inhibiting direct-to-metal primer.

• Wood: Seal knots and stains with IAQ 5000 stain-blocking primer.

• Masonry Block: Apply IAQ 3000 block filler for a denser surface if desired.

Application

• Tools:

  • Brush: Synthetic, nylon, or polyester bristles

  • Roller: Synthetic fiber, 3/8” nap or longer

  • Spray: Airless spray with 2000-3000 PSI pressure; tip size .019 to .021

• Tinting:

  • Tint IAQ 6000 with up to 2 oz of universal colorant per gallon.

  • Begin with 50% of the tinting formula and adjust as needed. Suitable for off-white or pastel shades.

• Mixing & Thinning:

  • Supplied ready-to-use.

  • May thin sparingly with up to ½ pint water per gallon for proper consistency.

• Coating:

  • Apply generously and uniformly using brush, roller, or spray.

  • One coat may suffice, but two coats might be necessary on porous surfaces for full sealing.

Coverage

• Smooth surfaces: 250–400 sq. ft. per gallon

• Porous surfaces: 150–300 sq. ft. per gallon

Drying Time (@ 70°F, 50% RH)

• To touch: 1 hour

• Recoat: 4 hours